Jazzmaster Made In Japan 1966-1968 Reissue - Brushed Gold 15-1-gear-ratio

Jazzmaster Made In Japan 1966-1968 Reissue - Brushed Gold 15-1-gear-ratioThis replacement pickguard is made to fit the Fender Jazzmaster Made In Japan 1966 1968 Reissue model only. Made from black plastic with a very thin layer of simulated brushed gold on top. 2. 28mm thick (. 090") with a 45 degree outer bevelled edge. Close up side view profile:

The Pawn Shop Mustang Special has a modified offset Mustang body

so minor body routing adjustments may be necessary in some cases

String Thru Hole ctr Height= 23/32 in

switch and pickups and that will be enough to hold it in place - no adhesive required

featuring a slim profile which allows installation into even the slimmest necks

Sold and priced individually

articulate voice with firm lows and a clear upper edge

this 250k audio taper (log) pot is CTS's own push/pull pot allowing for various additional wiring possibilities such as coil-tapping or phase switching

5mm from base of the post to centre of the string hole)

Both brass saddles are held-in with an Allen key-adjusted central screw - loosening off this screw allows for the saddle to swivel to set the perfect position for improved string intonation

Fender Japan 2010 or newer

The socket that is supplied cannot be used as a strap button so you would need to purchase an alternative socket that allows this and then solder the socket to the cable