MSD - 36" Harness - Replacement - Use with MSD Flying Magnet Crank Trigger Kits

MSD - 36" Harness - Replacement - Use with MSD Flying Magnet Crank Trigger KitsEach pickup is wound on special bobbins and terminated to ur tinned conductor. Teflon jacketed wiring. A strain relief protects the wiring where it leaves the threaded housing. Once assembled, the wiring is placed in a vacuum chamber and the windings are potted in a fracture resistant epoxy component for durability in extreme conditions.

125 in Long - Bushed - 3/8 in Cap Screws - 8740 Bolt - Forged - Steel - Small Block Chevy - Set of 8

200 in Long - 19 mm 12 Point Head - Washer Included - Chromoly - Black Oxide - Ford Coyote - Each

Oil Pan Stud - Serrated Face Nuts - Grade 8 - Steel - Black Oxide - Small Block Chevy / V6 / Oldsmobile V8 - Kit

680 in Long - Roller - Steel - Black Oxide - Small Block Chevy - Each

00-inch mandrel-bent aluminized steel inlet pipe flowing into a Super 50 Series™ muffler for a deep powerful tone

Shock - SNS2 BV Series - Monotube - 15

Gear Oil - Free-Gear Estorlin - 80W90 - Synthetic - 1 qt - Each

75 in Wide x 2

500 in Diameter - Aluminum - Black Anodized - Universal - Each

Axle Shaft - 30 in Long - 31 Spline Carrier - 24 Spline Drive Flange - Solid - Steel - Natural - Each

The Harnesses plug directly into your factory coil and harness then four color coded wires plug into the corresponding wires of the MSD

NOTE: XXL available in black with inside seam only