S3 Clutch Bell Heatsink Cooler Bearings

S3 Clutch Bell Heatsink Cooler BearingsRunning an open CVT on your scoot and want to add some additional cooling AND bling! The new S3 heat sink checks all the boxes. Fits any clutch bell who's shaft is 10mm, uses two hex head set screws to lock in to place to prevent spinning. This can be used on a 12mm shaft, but you will need to drill the hole out. this will ONLY work if your back cover is open, it will not fit under the cover, use blue loctite on these, we're not liable if it takes off

and allow for maximum lever travel/ control

Oem starter

or provide your own if you want to use this in a elite/dio

Looking to build the meanest zuma (or other minarelli horizontal powered scoot

aprilia sr50

Choose from vertical or horizontal engines

Base gasket

Other essential components have also been revised

Perfect combo with the Motion Pro Zuma throttle cable

dio swapped

and heat shield

S23 CDI Box