Bottom or Side Button Mount - Modular Steering Assembly Hole Sizes:11.6mm

Bottom or Side Button Mount - Modular Steering Assembly Hole Sizes:11.6mmThis element is designed to facilitate up to 6 buttons and be mounted on either the top, bottom or sides. Available with either 7mm or 11. 6mm Holes but could be drilled bigger if required. 2mm Thick in raw Stainless Steel Our Modular Steering Wheel Components are Stainless Steel (raw finish) interchangeable components to facilitate the mounting of displays buttons dash laptimers shiftlights. For more information click here Please note that this item

All of the pictures on this listing use this kit

Remove the front bumper

Trim the dam ends to match the splitter (sheet metal shears or grinder)

Screw dam to the splitter (1/2" long screws)

No Dash/Display mount included in this listing

Re-fit the bumper (or splitter)

This is the centre hub to use if you only want to mount a dash on the steering column side of your quick release

this will probably more likely be used with our single mount centre hub on the steering column or our chassis weld on and bolt on tabs

TIG Weld the bush casing centrally in to the trailing arm with the circlip end facing the rear of the car (for ease of access)

in the other pictures

2mm Stainless bent at 90 degrees

Instructions